Launch of the JK-BMS RS485 add-on for Home Assistant

[ridedirtbikes]

this setting was already on, i did toggle it off then back on after a few seconds and the controls started to work. bad news is in this mode my inverter EG4 12kpv only see's the first battery. if i change to broadcasting: true my inverter is happy but i don't have controls, the control points will pull in if i toggle them from the jk android app but they are not controllable from home assistant. i switched back to broadcasting:false mode and had control issues again, a "rebuild" from your add-on got them working again. it would be perfect if i could run broadcast mode or switch 0000 and 1000 for the inverter but have all the control points from  1000 and 0100, seems like i've seen people figure this out but not sure if it's possible with your add-on? i can re-post this info in gethub if you would like, but if there is nothing further to work out here it's a moot point.

thanks